progress
Posted by
Gene
on 2002-03-13 21:29:51 UTC
I have got the slides all done and am mounting the motors now. I have
most of the required stuff. I have 3 gecko 201'S, I think I need a 12K
resistor to set the power supply to 1.4 amps. How big of a resistor
should this be? how many watts? I also have a 28 volt, ct, 4 amp
transformer and a bridge rectifier. What kind of cap would I need and
how do I hook it up? across the two output leads after the rectifier? I
know this sounds real stupid but I've been a machinist all my life and
never got into electronics much. I can wire houses and Ive fixed a TV or
two. Thank You .
most of the required stuff. I have 3 gecko 201'S, I think I need a 12K
resistor to set the power supply to 1.4 amps. How big of a resistor
should this be? how many watts? I also have a 28 volt, ct, 4 amp
transformer and a bridge rectifier. What kind of cap would I need and
how do I hook it up? across the two output leads after the rectifier? I
know this sounds real stupid but I've been a machinist all my life and
never got into electronics much. I can wire houses and Ive fixed a TV or
two. Thank You .