RE: [CAD_CAM_EDM_DRO] How bout this idea??
Posted by
Tim Goldstein
on 2002-03-13 21:18:58 UTC
I have some of the original model Gecko G201 stepper drives that I am
selling. The supply is almost gone from Gecko and I have about a 1 month
supply on hand at the rate they have been going. These are brand new
factory tested drives but sold as close-outs without any factory
support. Contact me off list for more information.
Tim
[Denver, CO]
http://www.KTMarketing.com/CNC.html
timg@...
selling. The supply is almost gone from Gecko and I have about a 1 month
supply on hand at the rate they have been going. These are brand new
factory tested drives but sold as close-outs without any factory
support. Contact me off list for more information.
Tim
[Denver, CO]
http://www.KTMarketing.com/CNC.html
timg@...
> Now I have to move on to either finding a DIY driver for 6amp stepper
> or just buy the Geckos and then convert over to ball screws
> at a later date. I did find a real nice chopper driver but was
> set up for ISA interface...
>
> Any sugestions for drivers ,commercial or home brew would be
> appreciated.
>
Discussion Thread
sspeed33317
2002-03-13 16:20:50 UTC
How bout this idea??
Doug Fortune
2002-03-13 17:24:52 UTC
Re: [CAD_CAM_EDM_DRO] How bout this idea??
JanRwl@A...
2002-03-13 19:58:23 UTC
Re: [CAD_CAM_EDM_DRO] How bout this idea??
deanc500
2002-03-13 20:04:23 UTC
Re: How bout this idea??
sspeed33317
2002-03-13 20:26:38 UTC
Re: How bout this idea??
Paul R. Hvidston
2002-03-13 20:45:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: How bout this idea??
deanc500
2002-03-13 20:53:12 UTC
Re: How bout this idea??
wanliker@a...
2002-03-13 20:55:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: How bout this idea??
Tim Goldstein
2002-03-13 21:18:58 UTC
RE: [CAD_CAM_EDM_DRO] How bout this idea??
Paul R. Hvidston
2002-03-13 21:44:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: How bout this idea??
Doug Fortune
2002-03-13 22:01:51 UTC
Re: [CAD_CAM_EDM_DRO] Re: How bout this idea??
Jon Elson
2002-03-13 23:11:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: How bout this idea??
Jon Elson
2002-03-13 23:22:41 UTC
Re: [CAD_CAM_EDM_DRO] Re: How bout this idea??
Brian
2002-03-14 16:53:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: How bout this idea??