Re: another Vexta stepper question.....

--- In CAD_CAM_EDM_DRO@y..., "RC" <asdf@c...> wrote:

> Vexta stepper Mod. c518-9212, need to know the oz. per inch holding

torque.

>
> Thanks,
> Russ

I think the C series are custom made ones for OEM use. Custom shaft
dimentions, flats, ect. I usually find a standard model that the
motor is close to (physically) and estimate from there using the spec
sheets I have and the info online. Ohm the windings, and or use the
Volt and Amp specs if listed, this should put you in the ballpark for
motors of the same size. Not very scientific but I've found no better
way to do it. Maybe someone else can shead some light on this.

mike