Re: [CAD_CAM_EDM_DRO] Re: EMC and Rounded Corners

Just a note that this can be caused by line blending as well. Make sure the
line blending is off in EMC or Master5 to get nice sharp corners. If this is
your problem raising your acceleration rates will minimize the effect if you
like the speed increase from blending and want to keep it on.
Art
Master5 Software
http://users.andara.com/~fenerty/master.htm

----- Original Message -----
From: "morgtod" <todmorg@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Sunday, April 14, 2002 2:27 PM
Subject: [CAD_CAM_EDM_DRO] Re: EMC and Rounded Corners


> Hi-
> I did not go back in the posts, but I think I remember you saying
> you are using EMC, I am using Master5 ( a variant of EMC ) and ran