Re: [CAD_CAM_EDM_DRO] flash cut canned cycles

Carl.... hi, here is a guess on how to fix, try looking into your ini file
for default drillling delays, or there maybe parameter your leaving out of
the G83......

Russ (russmixer)

----- Original Message -----
From: carlcnc <carlcnc@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, April 15, 2002 10:54 AM
Subject: [CAD_CAM_EDM_DRO] flash cut canned cycles


> Is it normal for Flashcut controller to have a delay each time you
> move to a new position when using G83?
> The point to point moves are fine but once there I get approx a 1.5
> sec pause before the drilling routine starts,then another delay after
> final peck and before the move to next location.
> Running on a P333 laptop W98.
> As we are drilling 250-400 holes for cribbage boards these "pauses"
> add up to 20 min!
>
> thanks
> Carl
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this as a
sister site to the CCED group, as many of the same memembers are there, for
OT subjects, that are not allowed on the CCED list.
>
>
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>