CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] software questions

Posted by wanliker@a...
on 2002-04-19 16:46:54 UTC
In a message dated 4/19/2002 3:00:46 PM Mountain Daylight Time,
rh@... writes:


> Is there a program where you draw the
> object and then the computer plots all the paths and does all the
> calculations determined by cutting width of your tool(Is this what a
> CAM program is) ?

Check out Vector.
bill


[Non-text portions of this message have been removed]

Discussion Thread

starcast82 2002-04-19 13:57:22 UTC software questions wanliker@a... 2002-04-19 16:46:54 UTC Re: [CAD_CAM_EDM_DRO] software questions workaholic_ro 2002-04-19 17:00:23 UTC Re: software questions stevenson_engineers 2002-04-19 18:30:50 UTC Re: software questions Ray Henry 2002-04-20 05:17:56 UTC Re: software questions ballendo 2002-04-20 05:31:49 UTC Re: software questions imserv1 2002-04-20 07:12:10 UTC Re: software questions follicely_challenged 2002-04-20 14:09:26 UTC Re: software questions