Re: Fanuc OT control File upload
Posted by
steveggca
on 2002-04-22 04:07:55 UTC
We always have used Procomm for Dos (www.shareware.com) as our never
fail software when setting up new machines and diagnosing problems
with machines and cabling (just as the cable connection is never
fail )
You can use Windows terminal if you set the serial port correct.
I'll have to ask about that, never did it myself, always used
procomm and then the customers cam software.
fail software when setting up new machines and diagnosing problems
with machines and cabling (just as the cable connection is never
fail )
You can use Windows terminal if you set the serial port correct.
I'll have to ask about that, never did it myself, always used
procomm and then the customers cam software.
--- In CAD_CAM_EDM_DRO@y..., fuddham@a... wrote:
> Steve,
> Thanks for the pin config. The one I had was wrong. I have
got the
> controller to act like it is sending, but I still do not get
anything on the
> PC. The program I have has no instructions and I connot get it to
the right
> program from the main menu. I have tried to go to the reader sub-
program,
> but it cannot access the com1 port. Maybe because it is not being
run from
> the main menu. Do you have a program that you can send me or
point me in the
> right direction for one?
>
> Thanks
>
> Scott Hamilton
Discussion Thread
fuddham
2002-04-17 19:14:22 UTC
Fanuc OT control File upload
steveggca
2002-04-19 04:03:49 UTC
Re: Fanuc OT control File upload
fuddham@a...
2002-04-19 19:18:50 UTC
Re: [CAD_CAM_EDM_DRO] Re: Fanuc OT control File upload
steveggca
2002-04-22 04:07:55 UTC
Re: Fanuc OT control File upload
scott wilson
2002-04-22 06:14:23 UTC
Re: [CAD_CAM_EDM_DRO] Re: Fanuc OT control File upload
fuddham@a...
2002-04-22 18:11:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: Fanuc OT control File upload
Carol & Jerry Jankura
2002-04-22 19:38:14 UTC
RE: [CAD_CAM_EDM_DRO] Re: Fanuc OT control File upload