So far, so good.

Hi all,
I've just uploaded 3 photos of the machine I'm building. They are loctated
in a folder called 'Homemade milling machine' in the photo section of this
group.
So far I have X and Y almost finished so next up is the Z-axis. The linear
bearings, ballscrews and T-slot table are from Isel. The table is 600X200mm
(~24"X8") and have a workable area of about 330X220mm (~13"X8"), the
ballscrews are 16mm with 4mm pitch and will be driven by Dan Mauch's 521oz
steppers (overkill) powered by G210's. I will upload a pic or two of the
driverbox shortly.
Any and all comments welcome.
/Henrik Olsson.