Re: [CAD_CAM_EDM_DRO] So far, so good.

Henrik

It looks like the Y axis screw is in the hole of the extrusion
Did you machine out an area on the top to connect it to the table?

Bill

> Hi all,
> I've just uploaded 3 photos of the machine I'm building. They are loctated
> in a folder called 'Homemade milling machine' in the photo section of this
> group.
> So far I have X and Y almost finished so next up is the Z-axis. The linear
> bearings, ballscrews and T-slot table are from Isel. The table is

600X200mm

> (~24"X8") and have a workable area of about 330X220mm (~13"X8"), the
> ballscrews are 16mm with 4mm pitch and will be driven by Dan Mauch's 521oz
> steppers (overkill) powered by G210's. I will upload a pic or two of the
> driverbox shortly.
> Any and all comments welcome.
> /Henrik Olsson.
>
>