Re: [CAD_CAM_EDM_DRO] So far, so good.
Posted by
William Scalione
on 2002-04-22 11:59:35 UTC
Henrik,
Looks good, so far. Where did you get the T-Slot table?
Bill
Looks good, so far. Where did you get the T-Slot table?
Bill
> Hi all,600X200mm
> I've just uploaded 3 photos of the machine I'm building. They are loctated
> in a folder called 'Homemade milling machine' in the photo section of this
> group.
> So far I have X and Y almost finished so next up is the Z-axis. The linear
> bearings, ballscrews and T-slot table are from Isel. The table is
> (~24"X8") and have a workable area of about 330X220mm (~13"X8"), the
> ballscrews are 16mm with 4mm pitch and will be driven by Dan Mauch's 521oz
> steppers (overkill) powered by G210's. I will upload a pic or two of the
> driverbox shortly.
> Any and all comments welcome.
> /Henrik Olsson.
Discussion Thread
Henrik Olsson
2002-04-22 10:50:31 UTC
So far, so good.
William Scalione
2002-04-22 11:59:35 UTC
Re: [CAD_CAM_EDM_DRO] So far, so good.
William Scalione
2002-04-22 12:14:32 UTC
Re: [CAD_CAM_EDM_DRO] So far, so good.
Henrik Olsson
2002-04-22 12:43:36 UTC
Re: [CAD_CAM_EDM_DRO] So far, so good.
Henrik Olsson
2002-04-22 12:56:32 UTC
Re: [CAD_CAM_EDM_DRO] So far, so good.
William Scalione
2002-04-22 17:06:07 UTC
Re: [CAD_CAM_EDM_DRO] So far, so good.
JanRwl@A...
2002-04-22 20:11:33 UTC
Re: [CAD_CAM_EDM_DRO] So far, so good.
Henrik Olsson
2002-04-23 08:19:21 UTC
Re: [CAD_CAM_EDM_DRO] So far, so good.