CAD CAM EDM DRO - Yahoo Group Archive

AC to DC ,,ONE LAST QUESTION... PLEASE!!!!

Posted by jeffdavis516
on 2002-04-23 23:03:28 UTC
I've been holding off from asking but this topic has not come up
yet. (I think)

It is possible to increase the AMPs if you somehow use two
transformers? What I mean is lets say if I want 20 amps output can I
use to 10 amp transformers and connect the secondary side somehow to
double the amps? The reason I'm asking this is because I was looking
on the Mouser web site for 20 amp transformers but could only find
24VAC @ 10 amp. I saw a little note at the bottom of the page about
wiring two transformers to get double the amps.

Any comments about this?


Thanks

Jeff Davis
http://www.homecnc.info

Discussion Thread

jeffdavis516 2002-04-23 23:03:28 UTC AC to DC ,,ONE LAST QUESTION... PLEASE!!!! bwrfromuk 2002-04-23 23:45:09 UTC Re: AC to DC ,,ONE LAST QUESTION... PLEASE!!!! Rose, Gary 2002-04-24 05:15:10 UTC RE: AC to DC ,,ONE LAST QUESTION... PLEASE!!!! Raymond Heckert 2002-04-24 20:47:52 UTC Re: [CAD_CAM_EDM_DRO] AC to DC ,,ONE LAST QUESTION... PLEASE!!!! JanRwl@A... 2002-04-25 17:01:26 UTC Re: [CAD_CAM_EDM_DRO] AC to DC ,,ONE LAST QUESTION... PLEASE!!!!