Re: [CAD_CAM_EDM_DRO] Re: Bridgeport feednut holder

It may also be referred to as a yoke. I just used the term that was
designated in the manual. It is the piece that holds both feednuts for
both the x and y axis. The bronze acme nuts are held in by a couple of
screws..Yoke sounds good. It may be possible to modify a stock piece to
fit these ballnuts. The outside diameter of the ballnuts is 1.560". Most
of the "kits" come with that piece included. You wouldn't happen to
have one laying around would you? Carey