Re: Bridgeport feednut holder

No I don't. The reason I asked is that it seems to be the biggest
problem in retrofitting. With inexpensive mills the yoke fasteners
seems to be different on every machine. You might want to look at

http://www.elrodmachine.com/yoke.htm

If you find an inexpensive solution please let me know.



--- In CAD_CAM_EDM_DRO@y..., "Carey L. Culpepper" <culpeppe@b...>
wrote:

> It may also be referred to as a yoke. I just used the term that was
> designated in the manual. It is the piece that holds both feednuts

for

> both the x and y axis. The bronze acme nuts are held in by a couple

of

> screws..Yoke sounds good. It may be possible to modify a stock

piece to

> fit these ballnuts. The outside diameter of the ballnuts is 1.560".

Most

> of the "kits" come with that piece included. You wouldn't happen to
> have one laying around would you? Carey