Re: Who runs CNC CONTROL on a Rotary Converter?
Posted by
Charles VanLeeuwen
on 1999-12-27 16:30:17 UTC
General rule of thumb is just under 2x single phase leg current versus 3
phase leg current. I think theoretical is 1.85 ish.
cvl
-----Original Message-----
From: David L Anderson <daveland@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Monday, December 27, 1999 12:41 PM
Subject: [CAD_CAM_EDM_DRO] Who runs CNC CONTROL on a Rotary Converter?
phase leg current. I think theoretical is 1.85 ish.
cvl
-----Original Message-----
From: David L Anderson <daveland@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Monday, December 27, 1999 12:41 PM
Subject: [CAD_CAM_EDM_DRO] Who runs CNC CONTROL on a Rotary Converter?
>From: David L Anderson <daveland@...>discussion of shop built systems in the above catagories.
>
>I looked over the logan actuator page on rotary converter designed. It
>was nice, but delt
>only with motors. I want to run my 3-phase (input) servo amps from
>single phase. They
>are 10 amp DC output @ 150Vdc.
>
>OK Guys... Which one of you runs your CNC control on a rotary single
>phase to 3 phase
>converter???? How do you size it??? I was going to go for 5Hp ( I
>think that is just below
>20 Amps @ 220V with 85% efficiency) Now if I "convert" that to 3 phase
>I guess I get
>only 33% of the current in each leg?? SO Can I get 6.6 amps ( 33% of 20
>amps) at 220V 3 phase into my 3 phase transformer for the servo
>amps??? Or is there a limit or losses in the rotary converter that limit
>the current in the generated leg?
>
>dave
>
>>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>For the FAQ, go to http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
Discussion Thread
David L Anderson
1999-12-27 12:42:17 UTC
Who runs CNC CONTROL on a Rotary Converter?
PTENGIN@a...
1999-12-27 13:24:39 UTC
Re: Who runs CNC CONTROL on a Rotary Converter?
Charles VanLeeuwen
1999-12-27 16:30:17 UTC
Re: Who runs CNC CONTROL on a Rotary Converter?
Igor Valentic
1999-12-28 04:51:16 UTC
Re: Who runs CNC CONTROL on a Rotary Converter?