Re: Problems with new sherline mill/camtronics system
Posted by
jeffdavis516
on 2002-05-10 10:43:14 UTC
I too just finished this board as well. To do a good test use only
ONE motor for now. If you have it working on the X axis, move the
motor with the same wiring to the Y axis. If you have trouble then
it's not the motor wiring.
Jeff
http://www.homecnc.info
ONE motor for now. If you have it working on the X axis, move the
motor with the same wiring to the Y axis. If you have trouble then
it's not the motor wiring.
Jeff
http://www.homecnc.info
--- In CAD_CAM_EDM_DRO@y..., "ggpipe" <ggpipe@y...> wrote:
> I ordered and assembled the camtronics 2A 3 axis kit and followed
the
> directions to the letter and passed the tests listed. I got my
> stepper motors in today from camtronics (160 oz in, 8 wire). I
wired
> the motors for series connection and hooked up the motors to the
> board. The x-axis works perfectly, but the y-axis is behaving
> strangely, when I step the y axis forward and back the stepper
steps
> somewhat randomly. I thought maybe the speed was set too fast, but
I
> lowered the speed until I could hear the individual steps and it
> still doesn't work right.
>
> BTW the rest of my config is a 13.5 V, 12 Amp switching power
supply,
> and the desknc software for DOS.
>
> I double checked the wiring to the stepper motor and it looks right.
>
> Any ideas on what to check?
>
> thanks,
> Glenn Pipe
Discussion Thread
ggpipe
2002-05-09 20:59:07 UTC
Problems with new sherline mill/camtronics system
cadcamcenter
2002-05-09 22:09:09 UTC
Re: Problems with new sherline mill/camtronics system
cadcamcenter
2002-05-09 22:29:57 UTC
Re: Problems with new sherline mill/camtronics system
bwrfromuk
2002-05-10 07:51:36 UTC
Re: Problems with new sherline mill/camtronics system
jeffdavis516
2002-05-10 10:43:14 UTC
Re: Problems with new sherline mill/camtronics system
ggpipe
2002-05-10 11:36:54 UTC
Re: Problems with new sherline mill/camtronics system