Re: The Resurection

Peter,

I will check the .ini file when I get home and see if I can get you the
exact numbers. I don't remember, but I think the Max speed is in inches per
second and if so, that may be the problem. I will verify the setting
tonight.

Tim
[Denver, CO]

----- Original Message -----

> From: "Peter Smith" <peter@...>
>
> Tim
>
> When you were using DeskNC, can you remember what settings you were using
> for ,
>
> Step signal, Poss or Neg
>
> Dir signal, Poss or Neg
>
> Start Vel SPS
>
> Accelleration SPS*S
>
> I have the board mounted in its box, and coupled to the Mill, but the
motors
> won't run from the computer, I am getting an erratic forward backward
> movement on all axis ( max speed set to 1), all axis run ok from the 555
so
> I may have some wrong connections on the input side
> of the socket,
>
> Best Wishes
> Peter Smith