Re: CNC robotic welding arms
Posted by
rainnea
on 2002-05-16 09:39:05 UTC
This is where I imagine that hard wired limit switches, E-Stops, etc.
would be critical. Possibly a floor pressure mat that would disable
the robot if anyone entered the danger zone ?
Post some picture of your lawnmower when you're finished will you ?
Rab
--- In CAD_CAM_EDM_DRO@y..., Unterhausen Umberto <unterhausen@y...>
wrote:
would be critical. Possibly a floor pressure mat that would disable
the robot if anyone entered the danger zone ?
Post some picture of your lawnmower when you're finished will you ?
Rab
--- In CAD_CAM_EDM_DRO@y..., Unterhausen Umberto <unterhausen@y...>
wrote:
> I have a GE P-50 welding robot. I don't recall the
> load capacity, but it is a big robot. The thing about
> such a beast that you must keep in mind is that it can
> easily kill you. They move fast and have a long
> reach.
> The one I own was used in a Penn State lab, and
> rotation was disabled for just this reason. They got
> a motion board that didn't drive the rotation axis.
>
> I thought about putting a router on the end. I think
> it would work relatively well for at least light
> routing.
>
> I decided that getting it to work was too much
> trouble.
> I had reservations about selling my robot whole
> because it had been dropped and the electronics were
> in a flood in my basement. So I am parting it out.
> It has wonderful DC motors, which I was going to use
> on my BP, but now I may use on my gantry router, or
> more likely sell. The large metal pieces are going to
> be made into mobile robots, one to mow my yard, and
> others to be battlebots.
>
> Eric
>
> __________________________________________________
> Do You Yahoo!?
> LAUNCH - Your Yahoo! Music Experience
> http://launch.yahoo.com
Discussion Thread
Shelbyville Design & Signworks
2002-05-15 12:36:25 UTC
Re: [CAD_CAM_EDM_DRO] CNC robotic welding arms
Unterhausen Umberto
2002-05-16 04:52:43 UTC
Re: CNC robotic welding arms
rainnea
2002-05-16 09:39:05 UTC
Re: CNC robotic welding arms
Mark Ehle
2002-05-16 11:18:43 UTC
[CAD_CAM_EDM_DRO] Re: CNC robotic welding arms
rainnea
2002-05-16 21:39:46 UTC
Re: CNC robotic welding arms
ths992001
2002-05-17 08:38:19 UTC
Re: CNC robotic welding arms
Mark Ehle
2002-05-17 08:56:02 UTC
[CAD_CAM_EDM_DRO] Re: CNC robotic welding arms
Jon Elson
2002-05-17 10:19:52 UTC
Re: [CAD_CAM_EDM_DRO] Re: CNC robotic welding arms
Ray Henry
2002-05-17 13:25:59 UTC
Re: Re: CNC robotic welding arms
rainnea
2002-05-18 06:49:55 UTC
Re: CNC robotic welding arms
Sven Peter
2002-05-18 12:19:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: CNC robotic welding arms