Controlling spindle, coolant from Camtronics 2A board
Posted by
ggpipe
on 2002-05-24 12:28:55 UTC
Is there an kit or pre-made board out there I can hook up to the
Camtronics 2A board, or do I need to get a parallel port splitter and
have a seperate box to controll those two? Ideally I would like to
have spindle speed control (the spindle motor is DC, so I could use a
H-bridge chopper controller), but a simple ON-OFF would work too. I
mostly want to be able to have the spindle turn off automatically
after a long job.
Camtronics 2A board, or do I need to get a parallel port splitter and
have a seperate box to controll those two? Ideally I would like to
have spindle speed control (the spindle motor is DC, so I could use a
H-bridge chopper controller), but a simple ON-OFF would work too. I
mostly want to be able to have the spindle turn off automatically
after a long job.
Discussion Thread
ggpipe
2002-05-24 12:28:55 UTC
Controlling spindle, coolant from Camtronics 2A board
Alan Marconett KM6VV
2002-05-24 13:45:44 UTC
Controlling spindle, coolant from Camtronics 2A board
RichD
2002-05-24 15:20:27 UTC
Re: [CAD_CAM_EDM_DRO] Controlling spindle, coolant from Camtronics 2A board