Re: Gecko 201's help

>I tried swapping the wires from pin
> 3to4 with each other and also the
> wires pin 5to6 with each other

did you do this in seperate steps ?

double check the stepper connections to make
sure you have the proper resistance and
that all the wires are connected properly.

Do you have an end switch installed
to stuff off the drives ?

Dave




but

> still the same!Well ,I know it must be the motor wires wrong but I

am

> afraid to try anything else without expert advice, as it was I

turned

> the power on with much trepidation! Oh by the way I tried it using
> CNCpro evaluation demo program.
> help please
> Mark (the nervous wreck)