Gecko 201's help
Posted by
markpowerplus
on 2002-05-31 03:36:32 UTC
Hi all!,
Just me again ,well.............I finally powered up the Gecko201's
but instead of the motors turning like they are supposed too they
were locked solid so to speak. I tried swapping the wires from pin
3to4 with each other and also the wires pin 5to6 with each other but
still the same!Well ,I know it must be the motor wires wrong but I am
afraid to try anything else without expert advice, as it was I turned
the power on with much trepidation! Oh by the way I tried it using
CNCpro evaluation demo program.
help please
Mark (the nervous wreck)
Just me again ,well.............I finally powered up the Gecko201's
but instead of the motors turning like they are supposed too they
were locked solid so to speak. I tried swapping the wires from pin
3to4 with each other and also the wires pin 5to6 with each other but
still the same!Well ,I know it must be the motor wires wrong but I am
afraid to try anything else without expert advice, as it was I turned
the power on with much trepidation! Oh by the way I tried it using
CNCpro evaluation demo program.
help please
Mark (the nervous wreck)
Discussion Thread
markpowerplus
2002-05-31 03:36:32 UTC
Gecko 201's help
rsgoldner
2002-05-31 04:40:10 UTC
Re: Gecko 201's help
turbulatordude
2002-05-31 05:08:59 UTC
Re: Gecko 201's help
Tim Goldstein
2002-05-31 10:28:04 UTC
Re: [CAD_CAM_EDM_DRO] Gecko 201's help