Reasons for using EMC
Posted by
mart_wid
on 2002-06-01 09:17:51 UTC
I'd be interested to hear peoples reasons for using EMC rather than
the likes of TurboCNC etc. It does seem to be difficult to setup and
get running reliably. If you design on the computer you cut with, it
also restricts the choice of CadCam programs unless you opt for a
dual-boot system.
Thanks, Martin.
the likes of TurboCNC etc. It does seem to be difficult to setup and
get running reliably. If you design on the computer you cut with, it
also restricts the choice of CadCam programs unless you opt for a
dual-boot system.
Thanks, Martin.
Discussion Thread
mart_wid
2002-06-01 09:17:51 UTC
Reasons for using EMC
bsptrades
2002-06-01 13:54:03 UTC
Re: Reasons for using EMC