RE: [CAD_CAM_EDM_DRO] Re: +5V geckodrive 201

Amen, I really like mine!! The PMDX-120 has it's own on board 5 volt supply
and can provide 5 volts to the Geckos or other drivers as needed. Works
great with all the control software I have tried it with including EMC,
TurboCNC, DeskNC, Master5 and Kcam3. I still need to wire up spindle on/off
to one of the built in relays and then figure out what to use the other's
for on my Sherline mill.

John Guenther
Sterling, Virginia
Too may projects,
Too little time!

> -----Original Message-----
> From: rcstickman [mailto:alantrest@...]
> Sent: Tuesday, June 04, 2002 9:04 AM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: [CAD_CAM_EDM_DRO] Re: +5V geckodrive 201
>
>
> You might also try this board. I am happy with mine.
>
> http://www.pmdx.com/PMDX-120/index.html
>
> Alan Trest
> Pensacola Florida
>
>
>
>
>
> --- In CAD_CAM_EDM_DRO@y..., "William Scalione" <wscalione@n...>
> wrote:
> > I'm not Bob, but he sells them here
> >
> > http://www.campbelldesigns.com/breakout_board.htm
> >
> > Bill
> >
> >
> > > --- In CAD_CAM_EDM_DRO@y..., "Bob Campbell" <bob@c...> wrote:
> > > > The break-out board that I use has a built in 5 volt supply.
> > >
> > >
> > > I need a break-out board to use with Geckos. Where did you get
> yours?
> > >
> > > Thanks in advance,
> > > John Champlain
> > >
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
> aol://5863:126/rec.crafts.metalworking or go thru Google.com to
> reach it if you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this
> as a sister site to the CCED group, as many of the same members
> are there, for OT subjects, that are not allowed on the CCED list.
>
>
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>