Re: [CAD_CAM_EDM_DRO] Re: +5V geckodrive 201

William Scalione wrote:

> > Which of the controller software have completely configurable pin-
> > outs?
> >
> > 1.CNCPro?
> > 2.Master5?
> > 3.TurboCNC?
> > 4.DeskNC for DOS?
> > 5.DeskNC for Windows?
> > 6.EMC?
> > 7.Flashcutcnc?
> > 8.Dolphin?
> > 9.MaxNC?
> > 10.
> > 11.
> > 12.
> > 13.
> > 14.
> > 15.?
> >
> > Andrew
>
> I can only speak for EMC, It is NOT configurable, but since you
> have the source code you could, if you can figure it out, change
> it to whatever you wish and recompile. So maybe we can call that
> sort of configurable.

Wait a minute. The step/direction pins are not user programmable, but
the assignment of auxilliary functions (spindle, coolant, drive power, etc.)
is configurable. So, that makes it partially configurable, but definitely not
"completely configurable".

Jon