Servo motors, software and Camtronics

Hello, Filipe Tomaz, Portugal

1 - I'm one step away from buying two servo motors, two Gecko drives
320 and one case with all the necessary stuff to Camtronics. This is
very trick to send about $1000 USD to someone that I don't know
personaly, 1000Km away from me. Anyone have any BAD experience with
Dan (Camtronics), expecially from EUROPE ?

2 - I need some advice with the software. After some reading, lots of
free sofware are avaiable, but almost all, only talk about the use
with steppers (open loop), like TurboCNC. Does anyone use a free
software with the G320/340 and with servo motors ?

3 - I'm going to create my second machine that can be seen in:

http://w3.ualg.pt/~ftomaz/darkcut/darkcut.html

4 - I will create step by step instructions to create similar
machines, to new folks, like I am now, don't have to go through all
the bad experiences that I'm in - this is, collecting usefull and
pratical information from the WWW.
This group is one of the best around !

By the way, Portugal is going to play tomorrow with USA. We are going
to win 2-1 !