CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Servo motors, software and Camtronics

on 2002-06-04 22:13:52 UTC
>
> 2 - I need some advice with the software. After some reading, lots of
> free sofware are avaiable, but almost all, only talk about the use
> with steppers (open loop), like TurboCNC. Does anyone use a free
> software with the G320/340 and with servo motors ?
>

Gecko G340's and EMC. This is closed loop to the drives,
open loop to EMC. Runs great.

Bill

Discussion Thread

ftomazz 2002-06-04 14:19:04 UTC Servo motors, software and Camtronics alenz2002 2002-06-04 18:57:35 UTC Re: Servo motors, software and Camtronics Tim Goldstein 2002-06-04 19:58:22 UTC RE: [CAD_CAM_EDM_DRO] Servo motors, software and Camtronics William Scalione 2002-06-04 22:13:52 UTC Re: [CAD_CAM_EDM_DRO] Servo motors, software and Camtronics bwrfromuk 2002-06-05 10:14:25 UTC Re: Servo motors, software and Camtronics