Re: [CAD_CAM_EDM_DRO] Re: Newbie building router ?

Hello Mark
Where are you in the UK
Regards

Peter Smith
Please reply to

peter@...

----- Original Message -----
From: "rmtuckeruk" <rmtucker@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Saturday, June 08, 2002 8:02 PM
Subject: [CAD_CAM_EDM_DRO] Re: Newbie building router ?


> Sorry Guys
> as i said im newbie
> not sure on load but hoping to rout wood etc
> using normal bosch router also a bit of brass if possible
> the driver cards are from alzanti.com,i do not think the problem is
> with the drivers, but may be the motors.as i said they are superior
> electic (slo-syn) M091-FC-315C 5.1V @ 1.3 AMPS PER PHASE UNIPOLAR
> im running them at 24v using power resistors.
> i can get far greater pulses per second but the motor drops out at
> about 3 r.p.m.
> i was mainly looking for anybody that may have used similar size
> motors on similar size machine etc.
> any more input you guys could give me would be greatly appreciated.
> i know surplus steppers in usa are quite common but here in uk they
> are not so not a lot of choice.
>
> mark
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this as a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
>
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>