Re: Grizzly Mini Mill- first look
Posted by
Jon Elson
on 2000-01-12 21:45:23 UTC
Ron Ginger wrote:
convert than a machine with a quill. (I know, I did a conversion on
a Bridgeport.)
Jon
> From: Ron Ginger <ginger@...><snip>
>
> I finally received the mini mill and got it setup. On the whole I think
> its a very nice little machine. In general the 'fit and finish' is quite
> nice. All the machined surfaces have a good finish, things operate
> smoothly, etc.
> There is no quill feed, the entire head moves up and down on a V-way, ItWhy won't a leadscrew work? It sounds like it would be EASIER to
> is driven by a rack and pinion with a 3 spoke hand wheel like a drill
> press. There is an adjustable stop you can set under the head to retun
> to a fixed position. I dont think a leadscrew conversion to the head
> will be practical. I'm going to continue as a 2D system, plan to operate
> the head manually.
convert than a machine with a quill. (I know, I did a conversion on
a Bridgeport.)
Jon
Discussion Thread
Ron Ginger
2000-01-12 08:09:47 UTC
Grizzly Mini Mill- first look
Marshall Pharoah
2000-01-12 07:32:13 UTC
Re: Grizzly Mini Mill- first look
MIADsgns@x...
2000-01-12 15:18:24 UTC
Re: Grizzly Mini Mill- first look
Marshall Pharoah
2000-01-12 16:38:39 UTC
Re: Grizzly Mini Mill- first look
Jon Elson
2000-01-12 21:45:23 UTC
Re: Grizzly Mini Mill- first look
Andy Clay
2000-01-13 02:53:12 UTC
Re: Grizzly Mini Mill- first look
Andy Clay
2000-01-13 03:18:34 UTC
Re: Grizzly Mini Mill- first look
MIADsgns@x...
2000-01-13 13:37:27 UTC
Re: Grizzly Mini Mill- first look
WBHINKLE@x...
2000-01-14 14:20:49 UTC
Re: Grizzly Mini Mill- first look