Gearing hardware help
Posted by
kdoney_63021
on 2002-06-13 11:24:43 UTC
I just spend most of the day looking for gear drive system parts. I
wanted a simple toothed belt driven system with a 2:1 ratio. What I
have is a motor with a .625" shaft. I can make the diameter of the
other end any reasonable size ~.5 - 1.5". What do you use? Who are
your suppliers?
One supplier had pieces but isn't $40/axis a lot to pay when I still
have to machine his parts to the proper ID?
wanted a simple toothed belt driven system with a 2:1 ratio. What I
have is a motor with a .625" shaft. I can make the diameter of the
other end any reasonable size ~.5 - 1.5". What do you use? Who are
your suppliers?
One supplier had pieces but isn't $40/axis a lot to pay when I still
have to machine his parts to the proper ID?