RE: [CAD_CAM_EDM_DRO] Servo motor selection

Can I make an simple suggestion? Have you contacted Dan at Camtronics
and asked him how he thinks this will work? Dan is a great supplier and
an honest guy. He also is very familiar with his products. I bet a
little e-mail to him would get you a prompt reply about how they would
work in your application.

Tim
[Denver CO]

> Mariss,
>
> Thanks again for your great 'top 10' post. Really awesome stuff. I
> have it printed out and sitting right next to me actually...
>
> I've gone through your calculations and they make perfect sense.
> Except for one thing, I'm not sure where you got 6000 RPM, but
> according to the Camtronics site, these motors are 900 RPM. Of
> course, this is significantly less, and things don't look good from
> there.

----Snip------