Table mounted tool holder
Posted by
daveland@n...
on 2000-01-21 11:47:59 UTC
The dirt problem can be solved by placing the tools at the far end of a large
table and having a sliding lid style cover. It could be activated by a switch
that the tool tip can be programmed to touch.
You're right that it gets more complex.
I did not think about sensors to detect the tool seating in the spindle. it
would be bad to try and cut with a half inserted tool!!! or worse yet to insert
a tool into an already filled holer position!!
dave
dave
table and having a sliding lid style cover. It could be activated by a switch
that the tool tip can be programmed to touch.
You're right that it gets more complex.
I did not think about sensors to detect the tool seating in the spindle. it
would be bad to try and cut with a half inserted tool!!! or worse yet to insert
a tool into an already filled holer position!!
dave
dave