Re: [CAD_CAM_EDM_DRO] Re: MOGLICE help!
Posted by
James Owens
on 2002-08-02 13:56:26 UTC
Where about on this site is the pdf, I couldn't find it?
Regards,
Terry
in addition to the graphite and moly additives, and (on paper at
least) seems to have a little better properties in general. It should
be pretty good for sliding ways too. I'll have some of my own results
in a few days. I'm reassembling my mill this weekend.
The Moglice manual (which you can download as a PDF from
http://www.moglice.com or ask them to mail you a printed copy) goes
into all the aspects of doing slide ways with Moglice as well as
leadscrew nuts. It talks about preparation, fixturing, casting,
trimming etc. and is a very good resource in the planning stages of
your project.
Best regards,
Randy
[Non-text portions of this message have been removed]
Regards,
Terry
> What kind of moglice should I use to replace the brass feed nuts onI used the 1000 fluid, San, because it has Teflon for lower friction
> my sherline(like seen in the "fun with moglice"folder in the photo
> section.
in addition to the graphite and moly additives, and (on paper at
least) seems to have a little better properties in general. It should
be pretty good for sliding ways too. I'll have some of my own results
in a few days. I'm reassembling my mill this weekend.
The Moglice manual (which you can download as a PDF from
http://www.moglice.com or ask them to mail you a printed copy) goes
into all the aspects of doing slide ways with Moglice as well as
leadscrew nuts. It talks about preparation, fixturing, casting,
trimming etc. and is a very good resource in the planning stages of
your project.
Best regards,
Randy
[Non-text portions of this message have been removed]
Discussion Thread
santorelli333
2002-08-01 18:30:17 UTC
MOGLICE help!
passive_i
2002-08-02 12:33:55 UTC
Re: MOGLICE help!
James Owens
2002-08-02 13:56:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: MOGLICE help!
Dave Hylands
2002-08-02 14:00:56 UTC
RE: [CAD_CAM_EDM_DRO] Re: MOGLICE help!
Randy Gordon-Gilmore
2002-08-02 14:11:36 UTC
Re: [CAD_CAM_EDM_DRO] Re: MOGLICE help!
Randy Gordon-Gilmore
2002-08-02 14:21:02 UTC
RE: [CAD_CAM_EDM_DRO] Re: MOGLICE help!
turbulatordude
2002-08-02 15:55:45 UTC
Re: MOGLICE help!
santorelli333
2002-08-02 17:36:24 UTC
Re: MOGLICE help!
Randy Gordon-Gilmore
2002-08-02 22:04:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: MOGLICE help!
Randy Gordon-Gilmore
2002-08-02 22:11:51 UTC
Re: [CAD_CAM_EDM_DRO] Re: MOGLICE help!
tauscnc
2002-08-03 07:54:13 UTC
Re: MOGLICE help!
Randy Gordon-Gilmore
2002-08-05 16:29:30 UTC
Re: MOGLICE help!