RE: [CAD_CAM_EDM_DRO] Re: MOGLICE help!

The link the PDF is broken. I sent an email to the contact address
requesting a non-broken one. We'll see what happens.

Dave Hylands

> -----Original Message-----
> From: James Owens [mailto:wotisname@...]
> Sent: Friday, August 02, 2002 2:06 PM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: Re: [CAD_CAM_EDM_DRO] Re: MOGLICE help!
>
>
> Where about on this site is the pdf, I couldn't find it?
>
> Regards,
>
> Terry
>
>
> > What kind of moglice should I use to replace the brass feed nuts on
> > my sherline(like seen in the "fun with moglice"folder in the photo
> > section.
>
> I used the 1000 fluid, San, because it has Teflon for lower friction
> in addition to the graphite and moly additives, and (on paper at
> least) seems to have a little better properties in general. It should
> be pretty good for sliding ways too. I'll have some of my own results
> in a few days. I'm reassembling my mill this weekend.
>
> The Moglice manual (which you can download as a PDF from
> http://www.moglice.com or ask them to mail you a printed copy) goes
> into all the aspects of doing slide ways with Moglice as well as
> leadscrew nuts. It talks about preparation, fixturing, casting,
> trimming etc. and is a very good resource in the planning stages of
> your project.
>
> Best regards,
>
> Randy
>
>
>
>
> [Non-text portions of this message have been removed]
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
> aol://5863:126/rec.crafts.metalworking or go thru Google.com
> to reach it if you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider
> this as a sister site to the CCED group, as many of the same
> members are there, for OT subjects, that are not allowed on
> the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY
> POSTING THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO
> EXCEPTIONS........
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@...
> [Moderator]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to

http://docs.yahoo.com/info/terms/