Re: Taig CNC conversion
Posted by
rainnea
on 2002-08-04 14:34:43 UTC
Very nice John,
what spindle have you ended up using with the Taig ?
what control software ?
Rab
--- In CAD_CAM_EDM_DRO@y..., "stevenson_engineers" <machines@n...>
wrote:
what spindle have you ended up using with the Taig ?
what control software ?
Rab
--- In CAD_CAM_EDM_DRO@y..., "stevenson_engineers" <machines@n...>
wrote:
> Managed to get the steppers fitted to my CNC conversion.like
> I've put three pics up on my web space.
> http://homepage.ntlworld.com/machines/taig1.jpg
> http://homepage.ntlworld.com/machines/taig2.jpg
> http://homepage.ntlworld.com/machines/taig3.jpg
>
> Taig1 is a shot of the X and Y axis. I went this way as I didn't
> the direct coupling method. It looked very prone to damage and itstepper
> also looks a lot like Prince Charles. This way if anything gets
> knocked it just spins on it's own centre and can't damage or bend
> anything.
> Looks a bit over kill but two HTD pullies and a belt were actually
> cheaper than an oldham coupling.
> I've kept the ratio at 1:1 and nothing on the machine has been
> modified at all. The square flange screws onto the original Taig
> thread and the box section bolts onto that. The timing pulley is
> bored 5/16", keywayed and secured with the original nut. The
> motor is free to slide up and down with two keep plates behing to
> save messing with nuts in a confined space.
> Taig2 is a close up shot of the Y axis and taig3 is a shot of the
> parts for the Z axis before fitting.
> I need to put some 2" diameter knurled knobs on the extended shafts
> so the screws can be turned by hand. I also have to make three
> blanking plates for the top of the box sections to stop rubbish
> falling down. This should finished the drive section of the machine.
>
> John S.
Discussion Thread
stevenson_engineers
2002-08-04 13:09:28 UTC
Taig CNC conversion
rainnea
2002-08-04 14:34:43 UTC
Re: Taig CNC conversion
stevenson_engineers
2002-08-04 15:36:44 UTC
Re: Taig CNC conversion
Alan Marconett KM6VV
2002-08-04 15:50:09 UTC
Re: [CAD_CAM_EDM_DRO] Taig CNC conversion
stevenson_engineers
2002-08-04 16:20:51 UTC
Re: Taig CNC conversion
Alan Marconett KM6VV
2002-08-04 16:46:57 UTC
Re: Taig CNC conversion
tauscnc
2002-08-04 22:20:36 UTC
Re: Taig CNC conversion