Re: Van Norman #12 Milling Machine
Posted by
PTENGIN@a...
on 2000-01-25 01:17:15 UTC
In a message dated 01/24/2000 7:48:52 PM Hawaiian Standard Time,
jmelson@... writes:
<< The only problem with this is that the machine will drop, by itself, some
hours after the compressor is shut off. >>
I suspect a spring applied motor brake would be a good investment on a z axis
application. They sell the packaged ones that sandwich between your motor and
machine.
Peter
jmelson@... writes:
<< The only problem with this is that the machine will drop, by itself, some
hours after the compressor is shut off. >>
I suspect a spring applied motor brake would be a good investment on a z axis
application. They sell the packaged ones that sandwich between your motor and
machine.
Peter
Discussion Thread
ronhenderson@e...
2000-01-21 19:10:04 UTC
Van Norman #12 Milling Machine
PTENGIN@a...
2000-01-22 00:58:01 UTC
Re: Van Norman #12 Milling Machine
Jon Elson
2000-01-22 21:31:04 UTC
Re: Van Norman #12 Milling Machine
Dan Falck
2000-01-23 05:30:01 UTC
Re: Van Norman #12 Milling Machine
Jon Elson
2000-01-23 22:24:08 UTC
Re: Van Norman #12 Milling Machine
Darrell
2000-01-23 22:29:27 UTC
Re: Van Norman #12 Milling Machine
PTENGIN@a...
2000-01-24 01:47:03 UTC
Re: Van Norman #12 Milling Machine
Bertho Boman
2000-01-24 05:26:20 UTC
Re: Van Norman #12 Milling Machine
Harrison, Doug
2000-01-24 15:10:46 UTC
RE: Van Norman #12 Milling Machine
Jon Elson
2000-01-24 21:45:50 UTC
Re: Van Norman #12 Milling Machine
Darrell
2000-01-24 23:35:17 UTC
Re: Van Norman #12 Milling Machine
PTENGIN@a...
2000-01-25 01:17:15 UTC
Re: Van Norman #12 Milling Machine
Bertho Boman
2000-01-25 03:29:58 UTC
Re: Van Norman #12 Milling Machine
tmay@u...
2000-01-25 12:26:16 UTC
Re: Van Norman #12 Milling Machine
Dan Falck
2000-01-25 15:45:16 UTC
Re: Re: Van Norman #12 Milling Machine
PTENGIN@a...
2000-01-25 19:18:01 UTC
Re: Re: Van Norman #12 Milling Machine
tmay@u...
2000-01-26 11:19:56 UTC
Van Norman #12 Milling Machine