CAD CAM EDM DRO - Yahoo Group Archive

Re: Advice needed?.

Posted by rmtuckeruk
on 2002-08-18 12:54:56 UTC
--- In CAD_CAM_EDM_DRO@y..., "Robert Campbell" <bob@c...> wrote:
> Mark,
>
> The numbers sound OK. 300 oz/in should be enough. I have used 350
oz/in on
> my gantry.
>
> Check your acceleration values. If you try and accelerate too fast
it will
> cause the stepper motors to stall.
>
> Like Fred said, check you power supply.
>
> What type drives are you using?
>
> Bob Campbell
>
> www.campbelldesigns.com
> ----- Original Message -----
> From: "rmtuckeruk" <rmtucker@l...>
> To: <CAD_CAM_EDM_DRO@y...>
> Sent: Sunday, August 18, 2002 12:14 PM
> Subject: [CAD_CAM_EDM_DRO] Advice needed?.
>
>
I have released the anti backlash nuts and the driver is a camtronics
bipolar chopper 5a.power supply i believe is 36v.

thanx
mark

Discussion Thread

rmtuckeruk 2002-08-18 12:14:27 UTC Advice needed?. grouchy_old_fred 2002-08-18 12:37:46 UTC Re: Advice needed?. Robert Campbell 2002-08-18 12:49:40 UTC Re: [CAD_CAM_EDM_DRO] Advice needed?. rmtuckeruk 2002-08-18 12:54:56 UTC Re: Advice needed?. Robert Campbell 2002-08-18 13:21:48 UTC Re: [CAD_CAM_EDM_DRO] Re: Advice needed?. rmtuckeruk 2002-08-18 14:15:46 UTC Re: Advice needed?. JanRwl@A... 2002-08-18 15:15:05 UTC Re: [CAD_CAM_EDM_DRO] Advice needed?. caudlet 2002-08-19 06:07:19 UTC Re: Advice needed?.