Cam Axial engine cam track code
Posted by
John Guenther
on 2002-08-21 05:02:05 UTC
I have created a folder, Cam-Axial-60 , in the files section and placed the
spread sheet and a gcode file in this folder. The gcode runs one iteration
of the track based on the coordinates provided in the construction article
in SIC. My rotary table is set up so that the y axis in the published
coordinates is the X axis on my setup. The code ran in TurboCNC without
problems although from listening to it I am not sure it will cut a smooth
track. Some refinement may be necessary to get a smooth cut. I will
attempt to cut it later when I get my current project off the rotary table.
I will probably cut it in wood just to save my round stock.
John Guenther
Sterling, Virginia
spread sheet and a gcode file in this folder. The gcode runs one iteration
of the track based on the coordinates provided in the construction article
in SIC. My rotary table is set up so that the y axis in the published
coordinates is the X axis on my setup. The code ran in TurboCNC without
problems although from listening to it I am not sure it will cut a smooth
track. Some refinement may be necessary to get a smooth cut. I will
attempt to cut it later when I get my current project off the rotary table.
I will probably cut it in wood just to save my round stock.
John Guenther
Sterling, Virginia
Discussion Thread
John Guenther
2002-08-21 05:02:05 UTC
Cam Axial engine cam track code
Alan Marconett KM6VV
2002-08-21 11:39:44 UTC
Re: [CAD_CAM_EDM_DRO] Cam Axial engine cam track code
Dan Statman
2002-08-21 11:56:20 UTC
Re: [CAD_CAM_EDM_DRO] Cam Axial engine cam track code
j.guenther
2002-08-21 12:02:01 UTC
RE: [CAD_CAM_EDM_DRO] Cam Axial engine cam track code
Alan Marconett KM6VV
2002-08-21 13:11:18 UTC
Re: [CAD_CAM_EDM_DRO] Cam Axial engine cam track code