RE: [CAD_CAM_EDM_DRO] Stepper selection
Posted by
Lloyd Leung
on 2002-08-27 19:39:46 UTC
Depends on your application, if you need ball screws or not. I have a
similar sized mill, and I RFQ some places, and got quotes back for all
three axis. I was looking about $2,200 USD dollars for balls screws.
So if you don't NEED ball screws, I'd suggest placing them on hold.
Is anyone able to get ball screws for MUCH less?
Steppers are not my specialty, so I'll leave it at this.
-----Original Message-----
From: Zafar Salam [mailto:zafar@...]
Sent: August 27, 2002 10:04 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Stepper selection
Hi all,
Need a little help here. I have a small mill (3 HP, 24"x7" bed, 12"x6"
travel) and I am planning to convert it to CNC. Could someone guide me
on the selection of stepper motors for it. What torque should I be
looking for. Would it be ok if I use the existing lead screws or should
I change them to ball screws too.
Regards,
Zafar
similar sized mill, and I RFQ some places, and got quotes back for all
three axis. I was looking about $2,200 USD dollars for balls screws.
So if you don't NEED ball screws, I'd suggest placing them on hold.
Is anyone able to get ball screws for MUCH less?
Steppers are not my specialty, so I'll leave it at this.
-----Original Message-----
From: Zafar Salam [mailto:zafar@...]
Sent: August 27, 2002 10:04 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Stepper selection
Hi all,
Need a little help here. I have a small mill (3 HP, 24"x7" bed, 12"x6"
travel) and I am planning to convert it to CNC. Could someone guide me
on the selection of stepper motors for it. What torque should I be
looking for. Would it be ok if I use the existing lead screws or should
I change them to ball screws too.
Regards,
Zafar
Discussion Thread
Zafar Salam
2002-08-27 19:03:41 UTC
Stepper selection
Lloyd Leung
2002-08-27 19:39:46 UTC
RE: [CAD_CAM_EDM_DRO] Stepper selection
turbulatordude
2002-08-27 19:55:17 UTC
Re: Stepper selection
bjammin@i...
2002-08-28 05:45:23 UTC
Re: [CAD_CAM_EDM_DRO] Stepper selection