Re: Gecko Fault/Reset Manager

> Also I'm wiring up home switches. I plan on using the encoder >

index

> pulse and a micro switch. Both will be inputed to a 74LS00 IC.
> Question is, Can I wire direct or do I need a resistor for the

encoder

> index. Three gates are used, X,Y, and Z. But EMC only needs one

input

> ,... can I tie the three gate's output together?

you would probably consider one axis homed when both the home switch
is on AND you get an index signal from the encoder.
But you need to tell EMC when any axis is at home, so i guess the
solution would be:
AND together the home switch and encoder index for each axis.
OR together the results and wire the result to the EMC home input.

EMC users: can you tell me how EMC does "homing" ? I would guess this
has to be done one axis at a time ?