Re: more stuff from automation controls

Sorry about that...especially since it is automation express, not
controls.

http://www.automationexpress.com/

Check the sections with the THK stuff....some nice slides and
ballscrews in there. Still a bit pricey.

--- In CAD_CAM_EDM_DRO@y..., "Michael Holm" <Michael@H...> wrote:
> A URL would be handy...
>
> Michael
>
> ----- Original Message -----
> From: "skykotechnologies" <skykotechnologies@y...>
> To: <CAD_CAM_EDM_DRO@y...>
> Sent: Saturday, October 12, 2002 12:11 AM
> Subject: [CAD_CAM_EDM_DRO] more stuff from automation controls
>
>
> >
> > Guys, you might want to check out the automation controls site
again
> > (the one with the older gecko drives; now that we know they are
> > another company just liquidating the inventory of the bankrupt
> > company). I just purchased two Daedal crossed roller bearing
tables,
> > 6 inch wide by 18 inches long with 12 inches of travel and weigh
> > 13lbs for $50 each! If you know anything about Daedal and/or
crossed
> > roller bearings, figure this was a screaming good buy. They have
a
> > load capacity of 280lbs...might make a decent precison x-y table.
> >
> > Other things they have are 1.1N-m stall torque brushless motors
for
> > $25, and 450oz inch rare earth magnet dual shaft stepper motors
for
> > $50. Some of the ballscrew stuff is very nice, but not
> > cheap....wonder if they will take offers...
> >
> > Richard
> >
> >
> >
> > Addresses:
> > FAQ: http://www.ktmarketing.com/faq.html
> > FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> >
> > OFF Topic POSTS: General Machining
> > If you wish to post on unlimited OT subjects goto:
> aol://5863:126/rec.crafts.metalworking or go thru Google.com to
reach it if
> you have trouble.
> > http://www.metalworking.com/news_servers.html
> >
> > http://groups.yahoo.com/group/jobshophomeshop I consider this
as a
> sister site to the CCED group, as many of the same members are
there, for OT
> subjects, that are not allowed on the CCED list.
> >
> > NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY
POSTING THEM.
> DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> >
> > Post messages: CAD_CAM_EDM_DRO@y...
> > Subscribe: CAD_CAM_EDM_DRO-subscribe@y...
> > Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@y...
> > List owner: CAD_CAM_EDM_DRO-owner@y..., wanliker@a...
> > Moderator: jmelson@a... timg@k... [Moderator]
> > URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> > bill,
> > List Mom
> > List Owner
> >
> >
> >
> > Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
> >
> >
> >