Re: [CAD_CAM_EDM_DRO] more stuff from automation controls

A URL would be handy...

Michael

----- Original Message -----
From: "skykotechnologies" <skykotechnologies@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Saturday, October 12, 2002 12:11 AM
Subject: [CAD_CAM_EDM_DRO] more stuff from automation controls


>
> Guys, you might want to check out the automation controls site again
> (the one with the older gecko drives; now that we know they are
> another company just liquidating the inventory of the bankrupt
> company). I just purchased two Daedal crossed roller bearing tables,
> 6 inch wide by 18 inches long with 12 inches of travel and weigh
> 13lbs for $50 each! If you know anything about Daedal and/or crossed
> roller bearings, figure this was a screaming good buy. They have a
> load capacity of 280lbs...might make a decent precison x-y table.
>
> Other things they have are 1.1N-m stall torque brushless motors for
> $25, and 450oz inch rare earth magnet dual shaft stepper motors for
> $50. Some of the ballscrew stuff is very nice, but not
> cheap....wonder if they will take offers...
>
> Richard
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this as a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>