more stuff from automation controls

Guys, you might want to check out the automation controls site again
(the one with the older gecko drives; now that we know they are
another company just liquidating the inventory of the bankrupt
company). I just purchased two Daedal crossed roller bearing tables,
6 inch wide by 18 inches long with 12 inches of travel and weigh
13lbs for $50 each! If you know anything about Daedal and/or crossed
roller bearings, figure this was a screaming good buy. They have a
load capacity of 280lbs...might make a decent precison x-y table.

Other things they have are 1.1N-m stall torque brushless motors for
$25, and 450oz inch rare earth magnet dual shaft stepper motors for
$50. Some of the ballscrew stuff is very nice, but not
cheap....wonder if they will take offers...

Richard