Re: Need help with Mill/Drill retrofit
Posted by
turbulatordude
on 2002-10-12 06:29:13 UTC
With such high effiency the ballscrews on a manual mode have a very
real possibility to letting the table fly the lenght to the stop.
if a cutter digs in, the resultant torque imparted into the workpiece
ergo the clamps and table, will have considderably more force than a
shorted stepper. And the screw offers no resistance.
Think of trying to brake your car on ice.
real possibility to letting the table fly the lenght to the stop.
if a cutter digs in, the resultant torque imparted into the workpiece
ergo the clamps and table, will have considderably more force than a
shorted stepper. And the screw offers no resistance.
Think of trying to brake your car on ice.
--- In CAD_CAM_EDM_DRO@y..., bjammin@i... wrote:
> At 07:30 AM 10/11/02 -0700, you wrote:
> >If you use ballscrews, then you may have problems in the manual
mode
> >(turning the crank).
>
> Not necessarily. One way is to use double-ended steppers which have
a
> certain amount of holding even when off and esp if off and shorted.
The
> handwheel goes on the dead end of motor shaft. The rest of setup is
left
> as-is.
>
>
>
> Regards, Hoyt McKagen
>
> To prevent virus propogation, don't put this addy in your book
> Belfab CNC - http://www.freeyellow.com/members/belfab/belfab.html
> US Best MC - http://www.freeyellow.com/members/batwings/best.html
> Camping/Caving -
http://www.freeyellow.com/members/batwings/caving.html
> Lots of people confuse breathing in and out, with living
Discussion Thread
protman16
2002-10-10 18:37:39 UTC
Need help with Mill/Drill retrofit
Dan Mauch
2002-10-11 07:24:32 UTC
RE: [CAD_CAM_EDM_DRO] Need help with Mill/Drill retrofit
Tim Goldstein
2002-10-11 09:42:00 UTC
Re: [CAD_CAM_EDM_DRO] Need help with Mill/Drill retrofit
William Scalione
2002-10-11 11:17:42 UTC
Re: [CAD_CAM_EDM_DRO] Need help with Mill/Drill retrofit
bjammin@i...
2002-10-12 05:39:00 UTC
RE: [CAD_CAM_EDM_DRO] Need help with Mill/Drill retrofit
turbulatordude
2002-10-12 06:29:13 UTC
Re: Need help with Mill/Drill retrofit
bjammin@i...
2002-10-13 06:11:27 UTC
Re: [CAD_CAM_EDM_DRO] Re: Need help with Mill/Drill retrofit
mgdcnc
2002-11-14 19:20:23 UTC
Re: Need help with Mill/Drill retrofit