Using Master5 with controller from SuperTech

on 2002-10-17 08:18:03 UTC

I have the servo taig machine I bought from Super-Tech.

The controller uses 3 Gecko servo controllers.

Would anyone think I would have trouble using the following combination
of software:

CAD -- Alibre
CAM -- VisualMill
NC -- Master5

Anyone else using a controller from Super-Tech with software other than
SuperCAM?

[Non-text portions of this message have been removed]

Discussion Thread

Michael Gamber 2002-10-17 08:18:03 UTC Using Master5 with controller from SuperTech Jeff 2002-10-17 13:34:53 UTC Re: Using Master5 with controller from SuperTech wanliker@a... 2002-10-17 13:49:39 UTC Re: [CAD_CAM_EDM_DRO] Re: Using Master5 with controller from SuperTech Michael Gamber 2002-10-17 13:51:24 UTC Re: [CAD_CAM_EDM_DRO] Re: Using Master5 with controller from SuperTech j.guenther 2002-10-17 14:09:11 UTC RE: [CAD_CAM_EDM_DRO] Re: Using Master5 with controller from SuperTech Art 2002-10-17 14:20:27 UTC Re: [CAD_CAM_EDM_DRO] Re: Using Master5 with controller from SuperTech Jeff 2002-10-17 18:16:27 UTC Re: Using Master5 with controller from SuperTech Tim Goldstein 2002-10-17 18:31:13 UTC RE: [CAD_CAM_EDM_DRO] Re: Using Master5 with controller from SuperTech