Re: [CAD_CAM_EDM_DRO] Re: Capacitors, no CAD, EDM, DRO content but maybe CNC

On Friday 18 October 2002 09:45 pm, you wrote:

But doesn't the voltage rating drop to half when you run caps in series and
double when you run them in paralell?

Scot


> SO, say two 33k resistors in series would equal to 66k resistance?
>
> And two 1000uF capacitors in parallel would equal 2000uF
> capacitance??
>
> Regards,
> Jim
>
> --- In CAD_CAM_EDM_DRO@y..., "Lloyd Leung" <lloyd@l...> wrote:
> > So:
> > - Resistors are in series [to gain resistance]
> > - Capacitors are in parallel [to gain uF]
> >
> > I really should remember that, but I've only use it maybe once in
>
> 23
>
> > years [once in my life thus far]
> >
> >
> >
> > -----Original Message-----
> > From: wanliker@a... [mailto:wanliker@a...]
> > Sent: October 18, 2002 11:16 PM
> > To: CAD_CAM_EDM_DRO@y...
> > Subject: Re: [CAD_CAM_EDM_DRO] Capacitors, no CAD, EDM, DRO
>
> content but
>
> > maybe CNC
> >
> > In a message dated 10/18/2002 5:15:26 PM Mountain Daylight Time,
> >
> > lloyd@l... writes:
> > > Btw, I forget if that was in series or parallel, it's been a few
> > > months
> >
> > Always in parallel to add values..............Often, makes a nicer
> > package
> > depending on the dimensions......
> > bill
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
> aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
> you have trouble. http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this as a sister
> site to the CCED group, as many of the same members are there, for OT
> subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
> DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/