RE: [CAD_CAM_EDM_DRO] Help with Kaluga/Mauch DRO card

Definitely no drivers needed. You just have to make sure it is on a
clear address that nothing else is using and that the address is enabled
in BIOS. Sometimes (frequently) Compaq does weird stuff that is
non-standard.

Tim
[Denver, CO]

> -----Original Message-----
>
> I am trying to install a 2 axis dro from Dan Mauch. I keep getting
> the "board not found" msg although I believe the jumper and address
> settings to be correct.
>
> This is a compaq presario with only dos command.com and basic system
> files loaded. Is there an ISA bus driver or something that needs to
> be installed?
>
> I'm sure I am missing something obvious.
>
> Any help appreciated.
> Joe V.
>
>