Help with Kaluga/Mauch DRO card
Posted by
onecooltoolfool
on 2002-10-22 18:35:41 UTC
I am trying to install a 2 axis dro from Dan Mauch. I keep getting
the "board not found" msg although I believe the jumper and address
settings to be correct.
This is a compaq presario with only dos command.com and basic system
files loaded. Is there an ISA bus driver or something that needs to
be installed?
I'm sure I am missing something obvious.
Any help appreciated.
Joe V.
the "board not found" msg although I believe the jumper and address
settings to be correct.
This is a compaq presario with only dos command.com and basic system
files loaded. Is there an ISA bus driver or something that needs to
be installed?
I'm sure I am missing something obvious.
Any help appreciated.
Joe V.
Discussion Thread
onecooltoolfool
2002-10-22 18:35:41 UTC
Help with Kaluga/Mauch DRO card
Alan Marconett KM6VV
2002-10-22 19:13:06 UTC
Re: [CAD_CAM_EDM_DRO] Help with Kaluga/Mauch DRO card
Tim Goldstein
2002-10-22 20:33:54 UTC
RE: [CAD_CAM_EDM_DRO] Help with Kaluga/Mauch DRO card