Re: [CAD_CAM_EDM_DRO] Help with Kaluga/Mauch DRO card

Hi Joe,

No driver to install, but I believe the address jumper on the board
needs to be set.

Alan KM6VV


onecooltoolfool wrote:

>
> I am trying to install a 2 axis dro from Dan Mauch. I keep getting
> the "board not found" msg although I believe the jumper and address
> settings to be correct.
>
> This is a compaq presario with only dos command.com and basic system
> files loaded. Is there an ISA bus driver or something that needs to
> be installed?
>
> I'm sure I am missing something obvious.
>
> Any help appreciated.
> Joe V.