Re: [CAD_CAM_EDM_DRO] Re: DRO issue "HEDs in hand"

Roger:
The strip has to be seperated from any support by a fraction of an inch
(1/4" I think), as the encoder surrounds the strip on three sides (as it
uses light passed through the strip to read the lines).

John

[snip]

> Dan, how did you mount the strip? I was thinking about a fiberglass
> plane to support the strip. Hopefully this would lessen the effects
> of temperature on the system, but perhaps this isn't needed.
> [snip]
> Thanks again, Roger Linscheid