Re: home made injection mold
Posted by
MIADsgns@a...
on 2000-02-04 23:08:51 UTC
In a message dated 2/4/00 3:29:57 PM SA Eastern Standard Time,
PTENGIN@... writes:
<< Mario,
Rio Grande Supply, the jewelry supply house sells a small plastic
injection machine. It has a pneumatic cylinder to push the injection ram.
Looks like a t-stat temp control, not a PID controller. I think it was for a
1/4 oz shot size. They sell all sorts of neat stuff for the machinist too.
Peter >>
Peter,
I have seen such, but its expensive. $3.5K last time I saw it on their
catalog.
They do have a lot of neat tools, but in general, jewlery tools are very
expensive.
Mario
PTENGIN@... writes:
<< Mario,
Rio Grande Supply, the jewelry supply house sells a small plastic
injection machine. It has a pneumatic cylinder to push the injection ram.
Looks like a t-stat temp control, not a PID controller. I think it was for a
1/4 oz shot size. They sell all sorts of neat stuff for the machinist too.
Peter >>
Peter,
I have seen such, but its expensive. $3.5K last time I saw it on their
catalog.
They do have a lot of neat tools, but in general, jewlery tools are very
expensive.
Mario
Discussion Thread
Joe Vicars
2000-02-03 07:27:27 UTC
home made injection mold
Dan Mauch
2000-02-03 08:28:55 UTC
Re: home made injection mold
MIADsgns@a...
2000-02-03 09:36:23 UTC
Re: home made injection mold
Ian Wright
2000-02-03 09:36:30 UTC
Re: home made injection mold
Steve Carlisle
2000-02-03 17:26:05 UTC
Re: home made injection mold
Steve Carlisle
2000-02-03 17:44:47 UTC
Re: home made injection mold
Area51tats@a...
2000-02-03 19:14:24 UTC
Re: home made injection mold
MIADsgns@a...
2000-02-03 20:26:11 UTC
Re: home made injection mold
William Scalione
2000-02-03 21:00:54 UTC
Re: home made injection mold
MIADsgns@a...
2000-02-03 20:59:10 UTC
Re: home made injection mold
MIADsgns@a...
2000-02-03 21:12:41 UTC
Re: home made injection mold
Matt Shaver
2000-02-03 21:41:18 UTC
Re: home made injection mold
hansw
2000-02-03 21:45:14 UTC
Re: home made injection mold
Matt Shaver
2000-02-03 22:02:54 UTC
Re: home made injection mold
PTENGIN@a...
2000-02-04 10:27:45 UTC
Re: home made injection mold
PTENGIN@a...
2000-02-04 10:29:56 UTC
Re: home made injection mold
John Ross
2000-02-04 10:48:25 UTC
RE: home made injection mold
MIADsgns@a...
2000-02-04 23:08:51 UTC
Re: home made injection mold