Re: [CAD_CAM_EDM_DRO] Reviving my mill (EMC)
Posted by
William Scalione
on 2002-11-06 18:30:18 UTC
John,
Pleease keep it on the list, or better yet, move it to the EMC list.
Thanks
Bill
Pleease keep it on the list, or better yet, move it to the EMC list.
Thanks
Bill
> I've been away from the CAD_CAM_DRO world for a couple
> of years and dusted off my mill (a grizzly mini mill
> I converted with EMC...). I've got some dust or gremlins
> in it because my system is hanging any time I try a
> move... I'll need to work those things out.
>
> I wrote my own parallel interface to use a 24 bit digital
> IO card for I/O and added a few other things in there
> like controlling spindle on/off over the RS232 port.
> Now I'm thinking I need to upgrade and get things
> a little more current, so I either need to re-wire
> or port my changes up.
>
> I'm using linux 2.2.14 with rtl 2.2, (I'm still
> trying to figure out which version of EMC I'm running,
> but it's about 2 years old). My system has problems with
> circular interpolation (I,J type G02/3 moves)...
>
> Right before I got too busy for the mill, the BDI had come out.
> (although I was not terribly interested it as I had gotten
> EMC working the slow way)..
>
> Anyway, I was hoping that some of the EMC guys around here
> might contact me off list (unless you think that it's
> valuable to the group) and bring me up to speed on the tips
> and tricks to the newer EMC and what platforms (distro and
> RTL, etc) are best for building it up again.
>
> One thing I'm considering is building my next EMC system up
> under peewee linux, since then the system runs out of RAM
> or read-only mounted hard-disk, and hence no fscking of file
> systems or waiting to power stuff off. (I'm using this, running
> linux off of 4MB flash cards for other projects).
>
> Thanks, and sorry for bothering the list.
>
> Thanks,
> murph
>
> Erie, CO
>
Discussion Thread
John Murphy
2002-11-06 18:04:04 UTC
Reviving my mill (EMC)
William Scalione
2002-11-06 18:30:18 UTC
Re: [CAD_CAM_EDM_DRO] Reviving my mill (EMC)
Ray Henry
2002-11-07 06:54:25 UTC
Re: Reviving my mill (EMC)
William Scalione
2002-11-07 07:53:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: Reviving my mill (EMC)
Dave Lantz
2002-11-07 09:17:56 UTC
RE: [CAD_CAM_EDM_DRO] Re: Reviving my mill (EMC)
bschwand
2002-11-07 12:01:12 UTC
Re: Reviving my mill (EMC)